| Official Luthiers Forum! http://www-.luthiersforum.com/forum/ |
|
| Carbon Fibre neck rods http://www-.luthiersforum.com/forum/viewtopic.php?f=10102&t=2113 |
Page 1 of 1 |
| Author: | Daryl [ Tue Jun 07, 2005 6:52 am ] |
| Post subject: | |
I'm looking for a supplier of 1/4" X 3/8" carbon fiber neck rods. I'm aware that LMI and Stewart MCdonald supply rods but I'm looking for a less expensive source. |
|
| Author: | crazymanmichael [ Tue Jun 07, 2005 6:54 am ] |
| Post subject: | |
have you checked the archives. i believse someone posted on this not long ago. |
|
| Author: | Sprockett [ Tue Jun 07, 2005 7:02 am ] |
| Post subject: | |
Try Composite Graphics in tehachapi, I've dealt with them for years and they have good service and good products. -Paul- |
|
| Author: | John How [ Tue Jun 07, 2005 7:15 am ] |
| Post subject: | |
Google turned up this and more. Lance, this may be one for your online resources page as it comes up once every couple months. |
|
| Author: | Mattia Valente [ Tue Jun 07, 2005 8:21 am ] |
| Post subject: | |
correct me if I'm wrong, John, but that source doesn't look to be crazy amounts cheaper than LMI or StewMac if you buy, say, 8 rods at once. |
|
| Author: | Daryl [ Tue Jun 07, 2005 8:49 am ] |
| Post subject: | |
I'm familiar with CST and Aerospace, I've ordered from both in the past, But I didn't see any large bar stock listed. I've spent a lot of time googling and still haven't come up with a supplier. LMI is the closest at $17.55 each. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|